3D Metal Frunk Logo Badge Overlay

This premium 3D metal badge overlay is crafted from aluminum alloy and installs directly over the factory front trunk T logo of your Tesla Model 3 or Model Y. It features a sophisticated hollow design and is available in Silver, Grey, or Black finishes to provide a custom, high-end look for your vehicle's front end.

Transform your Model 3 or Model Y's front trunk logo with our premium 3D metal badge overlay. Crafted from high-strength aluminum alloy with a sophisticated 3D hollow design, this frunk emblem adds depth, dimension, and a custom touch to your vehicle's front end—elevating the standard T logo to a premium, eye-catching statement piece.

Choose Your Finish:

• Silver: Classic metallic finish—timeless, elegant appearance
• Grey: Modern gunmetal tone—sophisticated, understated look
• Black: Bold dark finish—sleek, murdered-out aesthetic

Product Specifications:

• Type: 3D metal frunk logo badge overlay
• Material: High-strength aluminum alloy
• Design: 3D hollow cutout (dimensional depth)
• Finish Options: Silver, Grey, or Black
• Size: 15×11×0.5cm (5.9"×4.3"×0.2")
• Adhesive: Double-sided automotive-grade foam tape
• Installation: Peel-and-stick overlay (no tools required)
• Placement: Front trunk (frunk) T logo
• Compatibility: Model 3 (2017-2025) & Model Y (2020-2025)
• Durability: Lifetime use, weather-resistant
• Appearance: Premium 3D design, factory-quality finish

Installation Guide:

Surface Preparation:

1. Clean the front trunk T logo area thoroughly with isopropyl alcohol
2. Ensure surface is completely dry and free of dust, wax, or oils
3. Work in moderate temperature (60-80°F / 15-27°C)

Installation Steps:

1. Test fit the badge over the factory T logo to verify alignment
2. Peel off the adhesive backing from the badge
3. Carefully align the 3D cutout with the factory T logo
4. Ensure the badge is centered and level
5. Press firmly in the center, then work outward to edges
6. Apply firm, even pressure across entire badge for 5 seconds
7. Press edges firmly to ensure complete contact
8. Allow adhesive to cure for 24 hours before car wash

Installation Time: Less than 5 minutes. No tools required.

Package Includes:

• 1x 3D Metal Frunk Logo Badge Overlay (finish as selected)
• Pre-applied double-sided foam adhesive
• Installation instructions

Removal Instructions (If Needed):

1. Warm badge with heat gun or hair dryer on LOW setting
2. Gently peel from one edge, applying heat as you go
3. Pull slowly at 45-degree angle
4. Remove adhesive residue with isopropyl alcohol or adhesive remover
5. Factory logo should be undamaged underneath

Why 3D Design Matters:

The 3D hollow cutout design provides multiple advantages:

• Creates dimensional depth (vs. flat stickers)
• Casts subtle shadows for visual interest
• Allows factory logo to show through cutouts
• Premium, sophisticated appearance
• Looks like expensive custom work
• Catches light from different angles