PLAID Letter Badge Emblem

This premium alloy PLAID letter badge emblem installs onto any flat surface of your Tesla using a peel-and-stick 3M automotive adhesive. It is available in four distinct finishes—Glossy Black, Matte Black, Red, or Silver—to provide a sporty, custom look that highlights your vehicle's performance status.

Showcase your performance credentials with our premium PLAID letter badge emblem. Crafted from durable alloy with your choice of four stunning finishes, this high-quality emblem adds a sporty, exclusive touch to your vehicle—celebrating the ultimate in electric performance with the iconic PLAID designation that represents Tesla's fastest, most powerful models.

Choose Your Finish:

• Glossy Black: Deep, reflective black finish—sleek and sophisticated appearance
• Matte Black: Non-reflective black finish—stealthy, murdered-out aesthetic
• Red: Bold red finish—sporty, high-performance look
• Silver: Classic metallic silver—timeless, elegant appearance

Perfect Placement Ideas:

• Rear fenders (classic performance badge location)
• Trunk lid or liftgate
• Front fenders
• Dashboard or center console
• Door sills or B-pillars
• Interior trim panels
• Charging port door
• Frunk lid

Product Specifications:

• Type: PLAID letter badge emblem
• Material: Premium metal alloy (durable and fade-resistant)
• Finish Options: Glossy Black, Matte Black, Red, or Silver
• Adhesive: 3M automotive-grade adhesive backing
• Installation: Peel-and-stick (no tools required)
• Weather Resistance: All-weather rated (rain, snow, sun)
• Durability: Fade-resistant, crack-resistant, peel-resistant
• Appearance: Bright colors, stylish and dynamic
• Compatibility: Universal—Model 3, Y, S, X, Cybertruck, any vehicle
• Placement: Any flat surface (exterior or interior)
• Removability: Can be removed if desired (adhesive is strong but removable)

Installation Guide:

Surface Preparation (Critical for Best Results):

1. Choose flat, smooth placement location (avoid curved surfaces)
2. Clean surface thoroughly with isopropyl alcohol (70%+)
3. Ensure surface is completely dry and free of dust, oil, wax, or moisture
4. Work in moderate temperature (60-80°F / 15-27°C) for best adhesion

Installation Steps:

1. Test fit badge position before removing adhesive backing
2. Mark placement with painter's tape if desired for perfect alignment
3. Peel off adhesive backing carefully
4. Align badge with desired position
5. Press firmly in center, then work outward to edges
6. Apply firm, even pressure across entire badge for 30 seconds
7. Press edges firmly to ensure complete contact
8. Allow adhesive to cure for 24 hours before car wash or rain exposure

Installation Time: Less than 5 minutes. No tools required.

Package Includes:

• 1x PLAID Letter Badge Emblem (finish as selected)
• Pre-applied 3M adhesive backing
• Installation instructions

Removal Instructions (If Needed):

1. Warm badge with heat gun or hair dryer on LOW setting
2. Gently peel from one corner, applying heat as you go
3. Pull slowly at 45-degree angle to avoid surface damage
4. Remove any adhesive residue with isopropyl alcohol or adhesive remover
5. Surface should be undamaged and ready for new badge if desired

What Does PLAID Mean?

PLAID is Tesla's designation for their highest-performance powertrain configuration, representing:

• Tri-motor all-wheel drive (three independent motors)
• 0-60 mph in under 2 seconds (Model S Plaid)
• Over 1,000 horsepower
• Top speeds exceeding 200 mph
• Ultimate performance and acceleration
• Flagship tier above Long Range and Performance variants